How To Fix A Roll Up Garage Door Spring

Sometimes the problem with your garage door can be traced to the opener.

How to fix a roll up garage door spring.

In the following section we ll show you how to replace a garage door opener. You may need to put approximatelty one revolution on the spring before bolting. Loosen the silver pipe wrench and pull down on the orange pipe wrench to loosen the spring more. Then attach the springs.

Ratchet with 7 16 and 1 2 sockets. This will prevent the door from shooting up and breaking your nose when you wind the new springs during an overhead garage door repair. Once the door is rolled up the spring can be stretched to the end plate and bolted. As the door is rolled down the spring will be charged.

Spring replacement with removal of door assembly. 3 8 and 5 16 nut drivers. Tighten them as needed and then spray each of the garage door springs with spray lubricant to help decrease the friction of the new door springs. Enter the unit with a ladder and manually roll the door up.

Hold the other end of the bar with one hand and loosen the lock nuts on the adjuster with a 3 8 inch open end wrench. A light gauge rollup door needs to actually be rolled up manually with the spring not yet attached. To replace your roll up door spring you ll need. Take the spring with you to the store so that you can choose the right size.

On roll up doors the spring tension is controlled by a cable on a pulley. 7 16 and 1 2 wrenches. Once your spring is unwound move to the right side of your self storage roll up door. Clamp a locking pliers or a c clamp to the track just above one of the rollers.

Continue this process until the spring is loose and is not transferring its torque along the shaft to the pipe wrenches. To adjust the tension pull the cable and reknot the end to shorten or lengthen the cable. 2 turn the garage upside down to locate the spring loaded door device at the top of the. The spring should be pinned to the shaft prior to rollup but not attached to the end plate.