Marbrex hygienic decorative internal cladding.
How to cut pvc wall panels.
If it s hard plastic you ll need to use a hacksaw.
Take your saw and cut an incision at one end of the panel slowly start to cut the panel in a straight line directly through the panel following your lined mark precisely once your panel is cut down to size it is ready to be installed as recommended if you have any further questions get in touch.
Marbrex decorative internal panels for walls and cielings provide an attractive practical and cost effect.
Push the paneling forward over the blade until.
If you want to cut the panels a stanley knife should suffice.
Once you are done use the sandpaper to sand out the cut edge.
Cutting the panels to size our pvc panels can be cut easily with basic hand tools such as a stanley knife hacksaw or even circular saw.
Measure the wall to check what size you need the plastic wall panels to be.
Measure the wall area where you plan to install your fiberglass panel.
If using a stanley knife simply score across the width of the panel and then it should break off in a straight line.
3 transfer this measurement to a sheet of fiberglass wall paneling and mark the sheet where you plan to make the cut.
Push down on the paneling as you hold it against the fence.
Next measure out the wall panel itself with the finished side up and mark the measurements onto the surface of the panel.
Take your saw and cut an incision at one end of the panel slowly start to cut the panel in a straight line directly through the panel following your lined mark precisely once your panel is cut down to size it is ready to be installed as recommended.
Fitting you wall panels.
Place the paneling on the saw.
Place one hand on the paneling on either side of the blade.
Installation onto walls ceilings.
What you use to cut the panel depends on the type of panel itself.
Make a pass on the panel using a metal rule and cut deeper with every cut.
Measure from floor to ceiling and transfer the measurements onto your panel using a pencil.