H Beam Vs I Beam Connecting Rods

Depending on the material you would want at least 900 inch of thickness in that area.

H beam vs i beam connecting rods.

With an h beam rod you should look at the thickness of the blades. H beam connecting rods incorporate two large flat sides with a thin section in the middle. Basically the h beam itself where the slot is cut out. Consequently h beam connecting rods are often recommended for high torque motors that produce a lot of power at low rpm under 6 000 rpm.

They are all 100 machined on all surfaces stress relieved and shotpeened. This design makes these rods more rigid and able to handle compression forces. All rods use arp 2000 bolts it is designed for durability with a little more material around the bolt. H beam rods are more difficult to machine so they are often more expensive.

H beam connecting rods have some additional things you want to look at before you pull the trigger on a set according to norris. Conversely h beam connecting rods are a little bit stiffer and rigid and that makes them ideal for higher horsepower higher torque applications where there is going to be more compressive forces again this comparison only holds true if your comparing rods with the same material finish and length. The ohio crankshaft h beam connecting rod is by far our most popular rod.